Replaced another Blade CP Tail Boom Today

I'm getting real good at this! I even replaced my tail motor...the original one was poping it's gear out on me -- the hobby shop guy says that's normal for these things. And, as you might guess, if the gear from the motor pops away from the big black tail rotor gear...you have no more tail rotor...and if you have no tail rotor, you're spinning out of control.

Tip: It's definately easier to replace the boom by un-soldering the wires from
the tail motor and sliding the boom off the wires...than trying to disconnect the wires from the receiver and pulling them through the boom that way.

Hey Joe...why you replacing your tail boom anyways? Good question. I have had my last few flights (See previous posts) on a boom that was slightly damaged and held together with some tape. Today, while making some tail rotor adjustments with the tail motor pot onboard the Blade...an adjustment I made was a bit too extreme, so I crashed and ruined my already damaged boom : )

The new boom and motor run great in my hovering tests...I can't wait till the next flying day to do some real flying.